The Modify menu appears.
In the <Position Select> group, the one of the [Top Left], [Top Right], [Bottom Left], and [Bottom Right] buttons that is on indicates the current display position of the DME wipe pattern.
2 In the <Position> group, press [Position], turning it on.
3 Depending on whether the DME wipe pattern is in one-channel mode or two-channel mode, proceed as follows.
In one-channel mode: press [1st Ch], turning it on.
In two-channel mode: from the <Ch Select> group, select the corresponding channel. You can select more than one channel at the same time.
4 To move the position of the DME wipe pattern, press the button where you want to move to, turning it on.
The DME wipe pattern displayed on the screen moves to the position of the specified button.
Setting relative positions to move the DME wipe pattern
In two-channel mode, use the following procedure.
1 In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’ The Modify menu appears.
Basic Procedure for DME Wipe Settings
In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’
1
Display indications when multiple channels are selected at the same time
The indications on the knobs show the settings of the lowest-numbered channel. When you turn the knobs to adjust the settings, this changes the settings on the other channels by the same amount.
To return the DME wipe pattern position to the center of the screen In the <Position> group, press [Center].
Displaying and moving the position of the DME wipe pattern (position select)
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
2 | V | Vertical position | |
|
|
|
|
472