6 In the <Main/Sub Link> group, make the main/sub modifier link function settings. (See “Main and sub modifier link function” (page 63).)

Full: fully linked mode

Semi: semi-linked mode

Applying the effect of a diamond dust wipe to the selected pattern (Dust mix)

1 In the Pattern Mix menu, press [Dust Mix], turning it on.

2 Set the following parameters as required.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Mix Ratio

Proportion of diamond dust

0.00 to 100.00

 

 

pattern in mix

 

 

 

 

 

2

H Size

Particle width

0.00 to 100.00

 

 

 

 

3

V Size

Particle height

0.00 to 100.00

 

 

 

 

4

Flash Rate

Rate of generation of particles

0.00 to 100.00

 

 

 

 

You can also apply the dust mix function to the pattern generated by a pattern mix.

Note

When a random/diamond dust wipe (pattern numbers 270-274) is selected, the dust mix function is not available.

Setting Wipe Modifiers

You can apply various modifiers to the wipe pattern: setting the wipe direction, pattern position, and so on.

For an overview of the wipe modifiers, see “Wipe Pattern Variation and Modifiers” (page 63).

Note that the available modifiers may depend on the pattern you are using. For details, see “Possible combinations of wipe patterns and modifiers” (page 454).

Main pattern and sub pattern modifiers

You can make independent settings of the modifiers for the main pattern and sub pattern.

Wipes 5 Chapter

Basic Procedure for Wipe Settings

443