•1381, 1391, 1393, 1394, 1396
When these pattern numbers are selected, you can set the center of the transition effect.
•2651, 2652
When these pattern numbers are selected, you can move the pattern for each channel, or with values relative to the current position the two channels simultaneously.
•2801 to 2804, 2811 to 2814
When the these pattern numbers are selected, you can set the vertical position as the brick slides in.
•2851 to 2854, 2861 to 2864
When these pattern numbers are selected, you can set the pattern position
for each channel setting when the first transition completes.
Pattern limit: You can restrict the range of the transition as desired. However, this is not available for a DME wipe in the independent key transition control block.
For more details, see “Pattern Limit” (page 355).
Size: This can only be used when one of the following pattern numbers is selected.
•1201 to 1208, 1221 to 1224, 1251
•2651, 2652, 2851 to 2854, 2861 to 2864 You can set the size of the image.
Crop: You can crop the image. It is also possible in 16:9 mode to crop both sides, to convert the image to a 4:3 aspect ratio. For the execution of a DME wipe crop transition, you can select from the following three possibilities.
•Cut
•Last 5%
•Linear
When [Last 5%] is selected, you can set the [Release Transition] as follows.
•Last 30%
•Last 5%
•Off
Notes
•When pattern numbers 1701 and 1702 are selected, crop cannot be used.
•The
Relation Between DME Wipes and Other Effects
The relations between DME wipes and other effects are as follows.
DME Wipes 81