2 Press the [Pattern Limit] button, turning it on.
3 Turn the knobs to adjust the following parameters.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Pattern Limit | Pattern limit | 0.00 a) to 100.00% b) |
a)0.00%: Executing the transition does not change the video output at all.
b)100.00%: The transition is the same as when no pattern limit is set, but the
Executing a pattern limit transition
1 Press the [PTN LIMIT] button, turning it on.
The button you pressed lights amber.
2 Carry out the transition.
The transition progresses as far as the set pattern limit. Even if the transition completes, the
3 Carry out the transition once again.
The status before the previous transition is restored.
To cancel the pattern limit
To cancel the pattern limit after completion of step 3 in the previous procedure, press the [PTN LIMIT] button, turning it off.
If after carrying out step 2 in the previous procedure, the pattern limit has been reached, carry out the following procedure.
1 Press the [PTN LIMIT] button.
The button you pressed lights green.
2 Carry out the transition.
The [PTN LIMIT] button goes off, and the pattern limit state is released. Depending on the way in which the transition was executed, the action will be as follows.
•When you press the [CUT] button, the pattern limit is immediately released, and the image switches instantaneously.
•When you press the [AUTO TRANS] button, until the state of the next transition, the transition is carried out over the duration given by the transition rate.
Executing a Transition 357