Transition Control Block and Flexi Pad Control Block (with INH button)

qs INH button

LIMIT

MIX

XPT HOLD

A B U1 U2 1 2 3 4

SET

 

 

 

PIN

NAM

INH

LIMIT

 

 

 

NORM

WIPE

WIPE

/REV

 

 

 

 

 

DME

REV

DME

 

 

 

SNAP

 

 

SHOT

TAKE

 

UNDO

Memory recall section

UNDO button

Control and Menus 2 Chapter

aTransition type selection buttons You can assign these buttons in setup to any transition type (see “Overall Control Panel Settings (Config Menu)” in Chapter 16 (Volume 2)). Press any of the following buttons, turning it on, to select the transition type.

Press one of these buttons, turning it on, to determine the type of the next transition for a background.

To select the key transition type, hold down the [KEY1] or [KEY2] button, and press one of the following buttons, turning it on. When multi-program mode is selected in the Setup menu (see “Settings for Switcher Configuration (Config Menu)” in Chapter 16 (Volume 2)), two or more of the following buttons may light.

MIX: In a background transition, the new video fades in as the current video

fades out. During the transition, the overall signal level is maintained at 100%.

In a key transition, the key fades in (for insertion) or out (for removal).

NAM (non-additive mix): The current and new video signals are compared, and the signal with the higher luminance level is given priority in the output. The current video is maintained at 100% output for the first half of the transition as the new video increases progressively to 100%, then the current video is progressively reduced from 100% to zero in the second half while the new video is maintained at 100%.

WIPE: The current video is replaced by the new video, using the wipe pattern selected in the Wipe menu.

Panel

Names and Functions of Parts of the Control Panel 301