Wipes DME 6 Chapter

Adjusting the DME wipe pattern cropping

Note

When pattern numbers 1701 and 1702 are selected, crop cannot be used.

1 In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’

The Modify menu appears.

2 Depending on whether the selected pattern is in one-channel mode or two- channel mode, proceed as follows.

For a pattern in one-channel mode: press [1st Ch], turning it on.

For a pattern in two-channel mode: from the <Ch Select> group, select the corresponding channel. You can select more than one channel at the same time. Some patterns need no selection which is fixed in the <Ch Select> group.

3 In the <Crop Mode> group, press [Crop], turning it on. 4 Set the following parameters.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Top

Crop the top of the image

–100.00 to +100.00

 

 

 

 

2

Left

Crop the left of the image

–100.00 to +100.00

 

 

 

 

3

Right

Crop the right of the image

–100.00 to +100.00

 

 

 

 

4

Bottom

Crop the bottom of the image

–100.00 to +100.00

 

 

 

 

Display indications when multiple channels are selected at the same time

The indications on the knobs show the settings of the lowest-numbered channel. When you turn the knobs to adjust the settings, this changes the settings on the other channels by the same amount.

In 16:9 mode, to crop to 4:3 aspect ratio

In the <Crop Mode> group, press [4:3], turning it on.

To set the action when a DME wipe crop transition is executed

1 In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’

The Modify menu appears.

2 Depending on whether the selected pattern is in one-channel mode or two- channel mode, proceed as follows.

474 Basic Procedure for DME Wipe Settings