Post-macro:Mode in which the macro is executed after carrying out the button function

Macro only: Mode in which the button function is not executed, and the macro only is executed

The selection of pre- or post-macro mode is carried out in the cross-point control block of the PGM/PST bank or the M/E banks. For the macro-only mode, assign the selection function to a utility/shotbox control block button or user preference button, and make the selection by pressing the button. Alternatively, without pressing the button, you can make the selection simply, by simultaneously pressing the pre-macro and post-macro selection buttons in the cross-point control block.

You can assign any one of the 99 macro registers to a button.

For a button whose function is switched by delegation, you can make a separate macro attachment for each function.

For each control panel, you can make up to 1000 macro attachment settings. The macro attachment setting is possible for the following bus buttons. For button locations, see pages in parentheses.

Block

Button

 

 

PGM/PST or M/E bank

• Background A row cross-point buttons (page 256)

 

• Background B row cross-point buttons (page 256)

 

• Key 1 bus cross-point buttons (page 256)

 

• Key 2 bus cross-point buttons (page 256)

 

• Key 3 bus cross-point buttons (page 256)

 

• Key 4 bus cross-point buttons (page 256)

 

• Utility 1 bus cross-point buttons (page 256)

 

• Utility 2 bus cross-point buttons (page 256)

 

• DME external video bus cross-point buttons (page

 

256)

 

• DME utility 1 bus cross-point buttons (page 256)

 

• DME utility 2 bus cross-point buttons (page 256)

 

• [AUTO TRANS] button a) (page 260)

 

• [CUT] button (page 260)

 

• [KEY1 ON] to [KEY4 ON] buttons a) (pages 260,

 

304)

 

• The button to which the same function as that of

 

VTR/disk recorder/Extended VTR/frame memory

 

clips play, cue, and stop buttons (page 260)

 

• Memory recall buttons i)

 

• Buttons set to “Inhibit” (page 256)

 

 

Auxiliary bus control block

• Cross-point button1st row b) (page 288)

 

• Cross-point button 2nd row b) (page 288)

Keyframe control block

• [RUN], [REWIND] and [FF] buttons (page 281)

 

• [NORM], [REV], and [NORM/REV] buttons (page

 

281)

Functions 8000-MVS 1 Chapter

Macros 219