Selecting Key Fill and Key Source

Selecting key fill and key source

To select key fill and key source for key 1 on the M/E-1 bank, use the following procedure.

1 In the M/E-1 >Key1 menu, select HF1 ‘Type.’

The Type menu appears.

2 In the <Key Fill> group, select either of the following for use as key fill.

Key Bus: signal selected on the key 1 fill bus

Matte: signal from the dedicated color matte generator

3 If you selected [Key Bus] in step 2, select the key fill signal on the key 1 row in the cross-point control block.

To select key fill for key 3 or key 4 in the cross-point control block, press the [KEY3] button or [KEY4] button to the right of the key bus buttons, turning it on, to allocate the key 1 row or key 2 row to the key 3 fill or key 4 fill, then press the desired cross-point button.

4 If you selected [Matte] in step 2, in the same Type menu, press the [Matte Adjust] button to display the Matte Adjust menu, then adjust the single- color or two-color combination color matte. Select whether to use a single- color matte or a two-color combination in the <Fill Matte> group.

Flat Color: Adjust color 1 with the following parameters.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Luminance

Luminance

0.00 to 100.00

 

 

 

 

2

Saturation

Saturation

0.00 to 100.00

 

 

 

 

3

Hue

Hue

359.99 to 0.00

 

 

 

 

Mix Color: Carry out a color mix. Adjust color 1 and color 2, and select a mix pattern (see the next section).

5 In the <Key Source> group, specify the key source selection mode.

Self: The key fill bus signal is automatically selected as the key source. When the key type is selected as chroma key, select [Self].

Auto Select: The signal allocated, being paired with the key fill bus signal, to a cross-point button is automatically selected as the key source. The setting of key fill and key source pairs is carried out in the Setup menu.

Keys 4 Chapter

Key Setting Operations Using Menus 387