gKF (keyframe) button
When the VTR/disk recorder/frame memory operation mode is enabled in setup, pressing this button cues the tape automatically to the start point. When not, pressing this button to turn it on allows you to use the fader lever as a key frame fader.
hKey status display
For each of keys 1 to 4, the corresponding ON indicator lights when the key is inserted. It also shows the priority (1 to 4) of each key.
iPRIOR (priority) SET button While this button is held down, you can set the key priority.
The setting mode when this button is pressed depends on whether or not the [KEY PRIOR] button is lit, as follows.
• When the [KEY PRIOR] button is off, the current key priority is set.
• When the [KEY PRIOR] button is lit, the key priority after the next transition is set.
Press the [KEY PRIOR] button as required, to switch between these two modes.
In either mode, hold down the [PRIOR SET] button, and press the button ([KEY1] to [KEY4]) corresponding to the key you want to bring to the front.
The following controls are used as the independent key transition control block.
jKey delegation buttons
These buttons delegate this independent key transition control block to a desired keyer. Press one of the [KEY1] to [KEY4] buttons ([DSK1] to [DSK4] in the PGM/ PST bank), turning it on.
You can press more than one button to select two or more keyers.
While these buttons are held down, you can select a key source with the
Pressing one of these buttons twice in rapid succession changes its state so that you can make
Key delegation button | Corresponding |
(double press) | key bus |
|
|
[KEY1] | key 1 a) |
[KEY2] | key 2 b) |
[KEY3] | key 3 c) |
[KEY4] | key 4 d) |
a)The key bus selection button [KEY3] in the cross- point control block goes off.
b)The key bus selection button [KEY4] in the cross- point control block goes off.
c)The key bus selection button [KEY3] in the cross- point control block lights.
d)The key bus selection button [KEY4] in the cross- point control block lights.
kIndependent key transition type selection buttons
Press one of the following buttons, turning it on, to select the independent key transition type.
MIX: Faded in or out.
WIPE: Inserted or deleted with a wipe.
DME (DME wipe): Inserted or deleted with a DME wipe.
lIndependent key transition execution section
KEY1 ON to KEY4 ON (DSK1 ON to DSK4 ON in the PGM/PST bank) buttons: Press the corresponding one of these buttons to cut key 1 to key 4 in or out instantaneously. When the key corresponding to the button appears in the final program output, the button lights red, and otherwise lights amber.
AUTO TRANS (transition) buttons: These correspond to keys 1 to 4 from left to right; press one to carry out an auto transition. The transition rate for an independent key transition can be
Names and Functions of Parts of the Control Panel 263