Key Snapshot Operations Using a Simple Transition Module

When using a simple transition module, the key snapshots hold the settings for key 3 and key 4. However, each key control block can be assigned to any key in setup (see Chapter 16 “Overall Control Panel Settings (Config Menu)” (Volume 2)).

You can carry out key snapshot operations in the independent key transition control block (simple type) and Flexi Pad control block (simple type). There are two dedicated key snapshot registers for each of keys 3 and 4.

 

Key 3 control block

Key 4 control block

Key source name display/key

 

 

 

 

 

 

snapshot buttons

 

 

 

 

 

 

K-SS button

K-SS

WIPE

DME

K-SS

WIPE

DME

 

SHIFT

MIX

CUT

SHIFT

MIX

CUT

 

 

KEY3

 

 

KEY4

 

 

 

ON

 

 

ON

 

 

 

TAKE

 

 

TAKE

 

The functions of the key 3 control block and key 4 control block are the same.

Independent key transition control block (simple type)

Saving a key snapshot

For example, to save the settings of M/E-1 key 3, use the following procedure.

1 In the M/E-1 independent key transition control block, press the [K-SS] button in the key 3 control block, turning it on.

This switches to key snapshot mode, and the key source name display/key snapshot button shows the state of registers 1 and 2 for key 3.

Off: Nothing is saved in the register.

Lit orange: Settings are saved in the register.

For a register holding a snapshot, the register name is shown as up to eight characters.

Keys 4 Chapter

Key Snapshots 435