DME Setup
In DME setup, carry out settings particular to the DME processor.
You can make the following settings.
Input signal settings (Input)
•Initial Crop: Make the initial crop setting.
•Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated by the DME internal matte generator on or off.
•System Phase: Adjust the operation timing of the whole system with respect to the reference signal.
•TBC Center: Set the TBC window center position.
Output signal settings (Output)
These settings are possible only when the DME is an
•Monitor Output: Set the signals output from the four monitor output connectors.
•Clip Adjust: Adjust the clip levels of DME1 and DME2 outputs.
Interface with external devices (Device Interface)
•Editor Protocol: Set the protocol to be used on the Editor port.
•Editor Port Setting: Make settings relating to the control of the four editor ports installed in the DME.
•GPI Input: Set the GPI input ports and trigger polarities, and make the action settings.
•GPI Output: Set the GPI output ports and trigger polarities, and make the action settings.
Setup Relating to DCU Input/Output
In DCU setup, carry out settings particular to the DCU.
You can make the following settings.
•Input Config: Assign GPI inputs to Parallel input ports.
•GPI Input Assign: Make GPI input settings.
•Output Config: Assign GPI outputs to parallel output ports inserted in an option slot.
•GPI Output Assign: Make GPI output settings.
•Serial Port Assign: Set the protocol to match the devices connected to a 9- pin serial port. You can also select the control panel used to control each device.
202 Setup