To make edge fill adjustments, carry out the settings in step 6.
4 Select the edge fill signal in the <Edge Fill> group.
Utility 1 Bus: signal selected on the utility 1 bus
Matte: signal from dedicated color matte generator.
It becomes possible to adjust color 1.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Luminance | Luminance | 0.00 to 100.00 |
|
|
|
|
2 | Saturation | Saturation | 0.00 to 100.00 |
|
|
|
|
3 | Hue | Hue | 359.99 to 0.00 |
|
|
|
|
When the edge type is outline, in place of the edge fill signal, the selected key fill signal fills the outline, and elsewhere remains as the background.
5 Carry out the following operation, depending on the selection in step 4.
When [Utility 1 Bus] is selected: Hold down the [UTIL] button in the
While the [UTIL] button is held down, the background A bus changes to the utility 1 bus.
Note
To enable the [UTIL] button, its operation mode must be set to [Hold] beforehand. (See “Operation Settings (Operation Menu)” in Chapter 16 (Volume 2).)
When [Matte] is selected: Press [Matte Adjust] in the same EDGE menu, to display the Matte Adjust menu, and adjust a single color or two- color combination color matte.
You can select whether to use a single color matte or a
For the color mix operation, see “Carrying out a color mix for the key edge fill matte” (page 394).
6 When emboss is selected for the edge type, adjust the color in the <Emboss Fill> group.
To adjust matte 1 press [Matte1], and to adjust matte 2 press [Matte2], then adjust the following parameters.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Luminance | Luminance | 0.00 to 100.00 |
|
|
|
|
392 Key Setting Operations Using Menus