Setting the independent key transition rate in the numeric keypad control block
Note
You cannot use the numeric keypad control block to set the transition rate for a simple transition.
1 In the numeric keypad control block, hold down the [TRANS RATE] button, and in the independent key transition control block, press the delegation button [KEY1] to [KEY4] ([DSK1] to [DSK4] in the PGM/PST bank) for the key for which you want to set the transition rate.
The numeric keypad control block changes to the mode for inputting the independent key transition rate, and its display now shows the corresponding region name and the current transition rate set for the region.
2 With the numeric keypad, enter the transition rate.
•Enter a value of up to three digits.
•To clear the entry value, press the [CLR] button.
For details of frame input mode and timecode input mode, see page 352.
3 Press the [ENTER] button.
This confirms the entry, and the selected region name and the set transition rate appear in the numeric keypad control block display.
To enter a difference from the current value
After pressing the
To change the sign (+ or
Setting the independent key transition rate by a menu operation
1 In the M/E or PGM/PST menu, select first the desired one from VF1 ‘Key1’ to VF4 ‘Key4,’ then HF6 ‘Transition.’
The Transition menu for the selected key appears.
2 Select any transition type in the <Transition Type> group.
If, in the Setup menus, you set insertion/deletion as independent modes, make the settings for insertion in the <On Transition Type> group, and the settings for deletion in the <Off Transition Type> group.
Independent Key Transitions 367