Control and Menus 2 Chapter

Lit pale blue: The function is enabled, and the parameters can currently be adjusted with the knobs.

Lit orange: The function is enabled.

Lit purple: Execution button. Pressing the button immediately executes the function. (Example: [Auto Start] button in the Chroma Adjust menu)

Pressing a button of this type displays a further menu, allowing more detailed settings. (Example: [Chroma Adjust] button in the Type menu)

Example: When wipe pattern key is selected

Setting parameters

This marking on a function button indicates that there are parameters which can be adjusted with the knobs.

Pressing this function button assigns parameters to the knobs.

You can set the parameter values by either of the following methods.

•Turn the knob (1 to 5) corresponding to the parameter, to adjust the value.

•Press the knob parameter buttons (1 to 5) corresponding to the parameter. This displays the numeric keypad window allowing you to enter the desired value.

In the description of specific setting procedures, the knob adjustment is described, as follows.

Panel

Knob

Parameter

Adjustment

Setting values

1

Size

Pattern size

0.00 to 100.00

 

 

 

 

2

Soft

Edge softness

0.00 to 100.00

 

 

 

 

3

Density

Key density

0.00 to 100.00

When the [MENU] button in the device control block is lit, you can use the trackball and Z-ring to control the parameters.

•Move the trackball on the x-axis to control the parameter for knob 1 or on the y-axis to control the parameter for knob 2. Moving up or to the right increases the parameter value, and moving down or to the left decreases the parameter value.

•Use the Z-ring to adjust the parameter for knob 3. Turning clockwise increases the parameter value, and turning counterclockwise decreases the parameter value.

Going back to the previous menu To return to the last displayed menu, press the previous page button.

Returning to default state in function groupings

1 Press the [Default Recall] button, turning it on.

This enters the menu default recall mode.

2 Press the VF button you want to return to the default state.

324 Basic Menu Operations