Sony 8000SF, MVS8000 manual 472

• When border is selected

Knob		Parameter	Adjustment	Setting values
1		Width	Border width	0.00 to 100.00
3		Luminance	Luminance	0.00 to 100.00
4		Saturation	Saturation	0.00 to 100.00
5		Hue	Hue	359.99 to 0.00
•	When soft border is selected

Knob	Parameter	Adjustment	Setting values
1	Width	Border width	0.00 to 100.00
2	Inner Soft	Border inner softness	0.00 to 100.00
3	Luminance	Luminance	0.00 to 100.00
4	Saturation	Saturation	0.00 to 100.00
5	Hue	Hue	359.99 to 0.00

Display indications when multiple channels are selected at the same time

The indications on the knobs show the settings of the lowest-numbered channel. When you turn the knobs to adjust the settings, this changes the settings on the other channels by the same amount.

Setting the DME wipe position (Positioner)

1 In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’

The Modify menu appears.

2 Depending on whether the DME wipe pattern is in one-channel mode or two-channel mode, proceed as follows.

For a pattern in one-channel mode: press [1st Ch], turning it on.

For a pattern in two-channel mode: from the <Ch Select> group, select the corresponding channel. You can select more than one channel at the same time.

3 In the <Position> group, press [Position], turning it on. 4 Set the following parameters.

Knob	Parameter	Adjustment	Setting values
1	H	Horizontal position	–200.00 to +200.00

Wipes DME 6 Chapter

Basic Procedure for DME Wipe Settings 471