Keys 4 Chapter

(See “Cross-Point Settings (Xpt Assign Menu)” in Chapter 16 (Volume 2).)

Split: You can select a key source signal independently of the key source automatically selected in Auto Select mode.

6 When [Split] was selected in step 5, hold down the [SPLIT] button in the key control block, then in the cross-point control block key 1 row, select the key source signal. Alternatively, hold down the key delegation button in the transition control block and press a cross-point button in the key 1 row to select the key source signal.

Notes

•In the above-stated key 1 row operation, you can only select a key signal assigned to a cross-point button. For the method of selecting a video signal, see “To select a video signal assigned to a cross-point button” below.

On the MVS-8000, the video signal selection operation is not supported.

•When [Split] is selected, the key memory function (see page 56) is disabled.

To select a video signal assigned to a cross-point button

By selecting the key source bus with an auxiliary bus control block AUX delegation button, and pressing the cross-point button, it is possible to select the video signal assigned to the cross-point button.

(If you press the cross-point button with holding down [KEY], the key signal assigned to the cross-point button.)

Note

In the above operation, the following settings must have been made.

•Assigning the key source bus to an AUX delegation button

For details, see “Auxiliary Bus Control Block Settings (Aux Assign Menu)” in Chapter 16 (Volume 2).

•Setting the [KEY] button operating mode

For details, see “Operation Settings (Operation Menu)” in Chapter 16 (Volume 2).

This operation is not supported on the MVS-8000.

Carrying out a color mix for key fill

When [Matte] is selected for key fill, you can combine color 1 and color 2. For the combination, you can use not only a key wipe generator pattern, but also the dedicated pattern for key edge color mix.

388 Key Setting Operations Using Menus