You can make the following settings.

Settings relating to overall switcher configuration (Config)

•System Phase: Adjust the switcher internal reference phase.

•Switch Timing: Specify the timing of video switching.

•M/E Config: Set the program configuration for the M/E and P/P outputs.

–Standard mode: Fix the maximum of four outputs (Out1 to 4) and program output configuration as follows.

Out1: Program output

Out2: Preview output

Out3: Clean output

Out4: Key preview output

Program output: Clean output + key 1 + key 2 + key 3 + key 4

–Multi-program mode: Increase the number of M/E or P/P programs, and assign any of the following to the maximum of six outputs (Out1 to 6). (M/ E Output Assign)

Program outputs 1 to 4, preview output, key preview outputs 1 and 2, clean output.

Further, you can select the program background from Clean or Utility2, and change the combination of signals from which it is configured. (PGM Config)

–DSK mode: Treat P/P as four DSKs, with no background transitions. Of backgrounds 1 to 4, set one to configure the program output. (PGM Config) The signals which can be selected as the background are limited to Out1 to 6 from M/E-1 to M/E-3.

Regardless of the current M/E Config mode, you can set the key preview configuration to be video mode or key mode. In key mode, select whether to link the key state to the on/off operation, or have it always on. (K-PVW Config)

•User 1 to 8 Config: Assign the User regions, being color backgrounds 1 and 2, AUX1 to 48, monitor 1 to 8, frame memory 1 to 8, and color correctors 1 and 2, to any of User1 to User8.

•Logical M/E Assign: Make settings for handling PGM/PST hardware logically as an M/E.

•DME Config: Set the DME channel assignments used on the individual M/E and PGM/PST banks.

•Side Flags: Make settings relating to the side flag function (inserting a selected image on both sides of a 4:3 image).

Input signal settings (Input)

•Input Phase Adjust: Carry out phase adjustment for each primary input.

•Through Mode: Set through mode for the input side. This applies only to the primary inputs, and can be set independently for each primary input.

Setup 199