2 In the <Ch Select> group, select the target channels.

3 Press [Position] in the <Position> group, turning it on.

4 Set the following parameters.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

4

Relative H

Relative movement in the

–400.00 to +400.00

 

 

horizontal direction

 

 

 

 

 

5

Relative V

Relative movement in the vertical

–400.00 to +400.00

 

 

direction

 

 

 

 

 

For details of the method of DME wipe pattern selection, see “DME Wipe Pattern Selection” (page 466).

Setting the DME wipe pattern size (Size)

1 In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’

The Modify menu appears.

2 Depending on whether the selected pattern is in one-channel mode or two- channel mode, proceed as follows.

For a pattern in one-channel mode: press [1st Ch], turning it on.

For a pattern in two-channel mode: from the <Ch Select> group, select the corresponding channel. You can select more than one channel at the same time.

3 Press [Size], turning it on.

4 Set the following parameters.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Size

Set size of effect

0.00 to 200.00 a)

a) The effect size when [Size] is off is taken as 100.00%.

Display indications when multiple channels are selected at the same time

The indications on the knobs show the settings of the lowest-numbered channel. When you turn the knobs to adjust the settings, this changes the settings on the other channels by the same amount.

Wipes DME 6 Chapter

Basic Procedure for DME Wipe Settings 473