Texas Instruments TMS320TCI648x manual Read This First

Preface

SPRUE13A – September 2006

Read This First

About This Manual

This document describes the Serial RapidIO® (SRIO) peripheral on the TMS320TCI648x™ devices.

Notational Conventions

This document uses the following conventions.

∙Hexadecimal numbers are shown with the suffix h. For example, the following number represents 40 hexadecimal (decimal 64): 40h.

∙Registers in this document are shown in figures and described in tables.

–Each register figure shows a rectangle divided into fields that represent the fields of the register. Each field is labeled with its bit name, its beginning and ending bit numbers above, and its read/write properties below. A legend explains the notation used for the properties.

–Reserved bits in a register figure designate a bit that is used for future device expansion.

Related Documentation From Texas Instruments

The following documents describe the C6000™ devices and related support tools. Copies of these documents are available on the Internet at www.ti.com. Tip: Enter the literature number in the search box provided at www.ti.com.

Implementing Serial RapidIO (SRIO) PCB Layout on a TMS320TCI6482 Hardware Design (literature number SPRAAB0) specifies a complete printed circuit board (PCB) solution for the TCI6482 as well as a list of compatible SRIO devices showing two DSPs connected via a 4x SRIO link. TI has performed the simulation and system characterization to ensure all SRIO interface timings in this solution are met; therefore, no electrical data/timing information is supplied here for this interface.

TMS320C6000 CPU and Instruction Set Reference Guide (literature number SPRU189) gives an introduction to the TMS320C62x™ and TMS320C67x™ DSPs, development tools, and third-party support.

TMS320C6000 Programmer's Guide (literature number SPRU198) describes ways to optimize C and assembly code for the TMS320C6000™ DSPs and includes application program examples.

TMS320C6000 Code Composer Studio Tutorial (literature number SPRU301) introduces the Code Composer Studio™ integrated development environment and software tools.

Code Composer Studio Application Programming Interface Reference Guide (literature number SPRU321) describes the Code Composer Studio™ application programming interface (API), which allows you to program custom plug-ins for Code Composer.

TMS320C64x+ Megamodule Reference Guide (literature number SPRU871) describes the TMS320C64x+ digital signal processor (DSP) megamodule. Included is a discussion on the internal direct memory access (IDMA) controller, the interrupt controller, the power-down controller, memory protection, bandwidth management, and the memory and cache.

TMS320TCI648x Bootloader User's Guide(literature number SPRUEC7) describes the features of the on-chip Bootloader provided with the TMS320TCI648x Digital Signal Processor (DSP). Included are descriptions of the available boot modes and any interfacing requirements associated with them, instructions on generating the boot table, and information on the different versions of the Bootloader.

14	Preface	SPRUE13A –September 2006
		Submit Documentation Feedback