Operating manual
Continuous JOG
In continuous jog, the axes keep moving while the jog keyboard is acted upon. Continuous jog allows moving several axes at the same time.
Proceed as follows:
1. Turn the jog selector switch(a) of the operator panel to the continuous jog position on the dial.
2. Jog the desired axis using the JOG panel (keypad). The axis will move while acting upon the JOG panel.
4.
(a)
If while moving, a second axis is selected, the new one will move at the same time and under the same conditions.
(JOG)MODE | with the axes |
If while the axes are moving, the rapid key is pressed, the axes will move at the rapid rate set by the machine manufacturer. This feedrate will be applied while that key is kept pressed and, when released, the axes will recover their previous feedrate. This rapid rate may be varied between 0% and 200% with the feedrate override switch on the operator panel.
Incremental JOG
In incremental jog, the axis moves a specific distance every time the key is pressed. In incremental jog, the axes may be jogged simultaneously.
Proceed as follows:
1.Turn the jog selector switch of the operator panel to one of the incremental jog positions. Each position will move the axis a fixed distance; the typical values are the following.
Selector position | Distance |
|
|
1 | 0.001 mm or 0.0001 inches |
10 | 0.010 mm or 0.0010 inches. |
100 | 0.100 mm or 0.0100 inches. |
1000 | 1.000 mm or 0.1000 inches. |
10000 | 10.000 mm or 1.0000 inches. |
|
|
2.Jog the desired axis using the JOG panel (keypad). Every time the JOG panel is acted upon, the axis will move the distance indicated on the dial of the jog selector switch.
If while moving, a second axis is selected, the new one will move at the same time and under the same conditions.
MANUAL | Operations |
CNC 8070
(SOFT V03.0X)
69
