Operating manual
14.5–Parameters and variables– service.
This service shows the list of parameters and/or variables of the drive. It is selected with the VIEW softkey of the horizontal menu.
The command bar is located at the bottom of the window. See "14.3 Command bar" on page 302.
Selection of the elements to be displayed
The VIEW softkey of the horizontal menu may be used to choose displaying either the parameters and variables, only the parameters or only the variables.
From the top of the window, it is possible to select:
•The drive whose parameters and/or variables are to be consulted.
•The group of parameters and/or variables to work with. Once selected, the list will show the elements of the selected group.
•The set of parameters to be consulted. Those parameters and/or variables that have sets will display the values of that set. Also, its identifier will show the selected set (e.g. for set 4 of the variable SP2, it will show SP2.4)
Parameters with a set will not be affected by the change.
List of variables and parameters
The list of variables and parameters offers the following information.
•Mnemonic of the variable or of the parameter.
•Current value at the drive.
•Units being used.
•Valid range of values. If it is a string of characters, it will show the maximum length permitted.
•Sercos identifier.
•Name of the variable or of the parameter.
Editing the values
The values, of parameters or variables with write permission are edited in the Value field. If the new value is accepted, the list shows the change.
The changes are saved in the drive's RAM memory. To save the change permanently, use the "DATA + FLASH" option of the horizontal menu.
14.
DDSSETUP | variables– service. |
|
CNC 8070
(SOFT V03.0X)
305
