‡ ‡ ‡ Operating manual

14.6–Error management– service.

This service shows the list of errors detected by the drive. The errors are shown in the order they come up.

Once the cause of the error has been corrected, the errors may be reset with the

ERROR RESET softkey of the horizontal menu.

14.

DDSSETUP

management– service.

 

–Error

The command bar is located at the bottom of the window. See "14.3 Command bar" on page 302.

Disabling the errors

To disable an error of the drive, use the ERROR LISTING softkey of the horizontal menu. This softkey shows the whole list of possible errors. To disable the desired ones, checkmark the box on the left.

Then, press the SEND softkey to send the list to the drive. To make the error disabling effective, execute the command DC1 (reset errors) from the command bar.

Disabling the errors requires an OEM or FAGOR access level. See "14.4 Changing the drives accessing level" on page 304. Even then, only resettable errors may be disabled, even if the list also shows the non-resettable errors.

CNC 8070

(SOFT V03.0X)

307

Page 341
Image 341
Fagor America CNC8070 manual Error management- service, Disabling the errors