![](/images/new-backgrounds/1111071/111071643x1.webp)
Operating manual
13.
SETUP ASSISTANCE | circularity (roundness) test |
| The |
Softkey menu
Horizontal softkey menu
The horizontal softkey menu offers the following options.
Softkey SIMPLE.
It captures the data of a full circle.
Softkey CONTINUOUS.
It captures data continuously.
Softkey STOP
It stops the data capture. This softkey is shown when data capture is running.
i | This softkey only stops the data capture. It does not stop the movement of the | |
axes. To stop the movement of the axes, press the [STOP] key of the operator | ||
| ||
| panel. |
Softkey CLEAR
It deletes the graphic representation. It may be done while the capture is running; in that case, it goes on with the graphic representation.
Softkey LOAD.
It loads a previously saved configuration.
Softkey SAVE.
It saves the configuration defined.
Vertical softkey menu
The vertical softkey menu offers the following options.
Softkey VALIDATE.
It saves the values of the machine parameters in the tables of the CNC and/or the drive accordingly.
When changing the values of the machine parameters, the changes are effective immediately. However, these changes are maintained only during the current session of the CNC; i.e. until the unit is turned off. On
Softkey INITIALIZE.
It resets the window data to its default values.
CNC 8070
(SOFT V03.0X)
288