‡ ‡ ‡ Operating manual

13.3.7 Validate the changes and save the configuration used

Validate the parameters

The new data is assumed by the CNC until the unit is turned off. Once the setup is completed, the changes must be saved so they can be effective next time the CNC is turned on.

Use the VALIDATE softkey to save the data. The CNC saves the new values in the CNC tables and/or in the drive tables accordingly.

When quitting the circularity test without having saved the parameters, the CNC will show a message warning about it and will give a chance to save them.

Save and load the configuration

The system permits saving the current configuration into a file in ASCII format (extension "TST"). This file only contains the configuration. It contains neither the graphics nor the values of the machine parameters. When loading a configuration, the parameters assume the value they have at the time.

i

The configuration saving option does not update the machine parameter

table. To do that, use the VALIDATE softkey.

Save the configuration

Press the SAVE softkey to save the current configuration. Select the folder and the file name and press [ENTER]. If there is a configuration already saved with the same name, it will ask whether it is to be replaced or not.

By default, the configuration is saved in the folder "C:\CNC8070 \MTB \DATA" or in the last folder selected by the user.

Load the configuration

Press the LOAD softkey to load a previously saved configuration. Select the folder and the file name and press [ENTER].

13.

SETUP ASSISTANCE

circularity (roundness) test

 

The

CNC 8070

(SOFT V03.0X)

295

Page 329
Image 329
Fagor America CNC8070 manual Validate the changes and save the configuration used, Validate the parameters