
Operating manual
14.9Command generator
This option may be used to configure and start up the internal command generator of the drive. In the configuration, it is possible to establish the shape of the signal, its amplitude, period, etc.
Selected drive
|
|
|
| Configuration of the command |
|
|
|
| |
|
|
|
| generator. |
|
|
|
| Turn the command generator |
|
|
|
| |
|
|
|
| |
|
|
|
| on. |
The fields to be configured at the generator are: | ||||
Shape | To select the type of signal to be generated with the drive | |||
| (sinusoidal or square). | |||
Amplitude | Signal amplitude. | |||
Frequency | Signal frequency. | |||
Offset | Signal Offset. | |||
Waves | Number of waves to generate. When set to 0 (zero), the | |||
| waves are generated continuously, without interruption. | |||
Duty Cycle | Percentage of the wave at 1/0 (only on squarewaves). |
The internal command generator is turned on and off using the lower buttons.
It turns the command generator on.
It turns the command generator off.
14.
DDSSETUP | Command generator |
CNC 8070
(SOFT V03.0X)
311