Operating manual
6.9.2Data editing
All data need not be defined; but it is recommended to define all the known data. To define the profile data, proceed as follows:
1.Press the softkey corresponding to the data to be defined.
2.Key in the desired value (which may be a numeric constant or an expression). Use the [SPACE] key to change the value of a
3.Press [ENTER] to accept the defined value or [ESC] to reject it and return to the previous one. If the entered value is accepted, the CNC will select the next data.
Once all the data has been defined, press the "Validate" softkey and the CNC will show the profile that has been defined.
Displaying incomplete sections
If there isn't enough data to show the defined section, the CNC will draw as much of it as it knows. The sections that are not fully defined will be shown with a dash line.
If there are more than one possibility, it will show the available options one by one except the ones that could generate tangency errors later on; select the desired option. The sections with several possibilities will be shown in green whereas the rest of the sections will be shown in white.
X1 | = ? |
|
Y1 | = ? |
|
X2 | = ? |
|
Y2 | = ? |
|
Angle = 60º | ||
Tangent = Yes | ||
X1 | = 40 | Y1 = 30 |
X2 | = ? | Y2 = ? |
Xc = ? | Yc = ? | |
Radius = 20
Tangent = Yes
6.
Profile editor | |
EDITING |
|
To select the available options.
To assume the selected option.
CNC 8070
(SOFT V03.0X)
137
