Operating manual
4.
(JOG) MODE | with the axes |
MANUAL | Operations |
4.2.4Moving an axis to a particular position (coordinate)
When moving the axes to a specific position, they must do so one by one following these steps:
1. Select the axis to be homed using the alphanumeric keyboard. The CNC will highlight that axis to indicate that it is selected.
To select the numbered axes (e.g. "X1"), select any axis and then move the selection until positioning on the desired one. The focus moves with the [©][ª] keys.
2.Enter the coordinate of the target point.
3.Press [START] to execute the movement or [ESC] to cancel the operation.
Feedrate behavior
The moving feedrate depends on whether G00 or G01 is active.
•If G00 is active, the movement is carried out at the rapid rate defined by the machine manufacturer.
•If G01 is active, the movement is carried out at the active feedrate. If no feedrate is active, the movement is executed at the feedrate defined by the machine manufacturer.
This feedrate may be varied between 0% and 200% using the feedrate override switch(a) on the operator panel. The percentage will be applied on to all the movements carried out in G00 and in G01.
(a)
CNC 8070
(SOFT V03.0X)
72
