
Operating manual
2.4Windows for warnings and errors
When an error occurs, the CNC will display a window describing the cause of the error. There are three types of errors. The top of the window shows the category and it will have a different color depending on the type of error it shows.
WARNING | Green window. |
ERROR | Red window. |
FATAL ERROR | Purple window. |
When several warnings and/or errors occur simultaneously, they are displayed from the one with the lowest priority to the one with the highest priority. The top right side of the window shows the priority level of the message. A down arrow indicates that there are errors with lower priority and an up arrow indicates that there are errors with higher priority. The operator can toggle the different active errors using the [©][ª] keys.
WARNING
It is just that, a warning.
They do not stop
ERROR
It may be a syntax error in a program, PLC generated errors, etc. They are errors that must be corrected.
They interrupt the execution of the program. Although the window displaying them may be closed by pressing [ESC], it does not mean that the error status has been taken care of. To do that, press [RESET]. After pressing [RESET] the CNC assumes the initial conditions set by the machine manufacturer with the machine parameters.
While the error window is active, no other action will be possible but removing it (it is not possible to change operating modes).
Refer to the error solving manual for a detailed description of the cause of the error and its possible solutions.
2.
THE CNC | and errors |
HOW TO OPERATE | Windows for warnings |
FATAL ERROR
They are errors that force the operator to turn the CNC off.
If the error persists, contact the Service Department at Fagor Automation.
CNC 8070
(SOFT V03.0X)
21