Operation manual
11.4.5 Find/Replace
It is used for searching for a line or a text in a program. It can also replace a text with another text.
When selecting this option, the CNC shows a dialog box requesting the line number or the text to look for. When defining a text search, certain options may also be defining that allow:
A. Replacing the text being searched with another in the program.
B. Ignore uppercase and lowercase.
C. Consider the text to find as a whole word.
D.Select whether the search starts at the beginning of the program or at the cursor position.
Find/replace
A
B
C
D
To move the cursor through the elements of the list.
To activate/deactivate the selection box (B) (C).
To select an option of a group (D).
To start the search.
To cancel the search and close the dialog box.
After defining the search options, press [ENTER] to start the search or [ESC] to cancel it.
The text found in the program will be highlighted and the softkey menu will show the following options:
•Replace, to replace the highlighted text.
•Replace all, to replace the text throughout the whole program.
•Find next, to skip this text and keep on searching.
To end the search, press [ESC].
11.
PLC | (softkeys) |
| Program editing |
8070 CNC
(SOFT V03.0X)
