Operating manual
13.
ASSISTANCE | Oscilloscope |
SETUP |
|
CNC 8070
Focus on the "C1" or "C2" field
Cursors "C1" and "C2" may be used to analyze each signal of the last data capture.
These two cursors may be used to obtain the position in milliseconds of each signal and the time difference between them "∆ ".
When the focus is on one of the fields "C1" or "C2", the following vertical softkeys will appear.
Takes the cursor to the beginning.
Takes the cursor to the end.
Takes the cursor to the trigger. If there is no trigger, it will go to the center of the window.
Moves the cursor to the left.
Moves the cursor to the right.
Focus on the "parameter name" field
As with variables, by selecting the various parameters, it is possible to change their names and values.
When pressing "Enter" after changing the name of a parameter, use the up, down, left and right arrow keys to move the focus to the next field to change the value of that parameter. After changing the parameter value and pressing "Enter", the focus does not go on to the next field. Use the arrow keys to go on to the next parameter.
When the focus is on this field, the 4 vertical softkeys will be:
It increases the value of the parameter in the amount indicated on the configuration screen.
It decreases the value of the parameter in the amount indicated on the configuration screen.
It resets the parameter to its default value.
It validates the value given to the parameter.
i | From the "CONFIG" mode, a screen may be accessed where it is possible to |
define the list of parameters to be displayed. |
(SOFT V03.0X)
274
