Fagor America CNC8070 manual Program execution, Start executing, Interrupting the execution

‡‡ ‡ Operating manual

3.6.2Program execution

3.

AUTOMATIC MODE	selection and execution
	Program

The name of the program selected in the channel for execution appears on the general status bar. See "3.1.2 Description of the general status bar" on page 36.

If not indicated otherwise, the program execution will begin from the first block of the program to the execution of one of the end-of-program functions "M02" or "M30". As an option, it is possible to define the first and last blocks of the execution. See "3.3 Data screen (softkeys)" on page 41.

Start executing

To start the execution of the program, press [START] on the Operator Panel.

The program may be executed in –single block– or –automatic– mode; the mode may be selected even while executing the program. When –single block– is active, the screen will display the relevant symbol on the general status bar.

If the –single block– mode is active, program execution will be interrupted at the end of each block; the [START] key must be pressed again to execute the next block. If the –automatic– mode is active, the program will be executed all the way to the end or up to the block selected as end of execution.

Interrupting the execution

The [STOP] key interrupts the execution of the program. Press [START] again to resume execution from where it was interrupted.

The execution may be interrupted at any time, except when threading. In that case, it will be interrupted at the end of the threading operation.

Stop the execution

The [RESET] key cancels the execution of the program and resets the CNC to its initial conditions.

i	The program selected for execution may be executed in any operating mode
	by pressing [START] on the Operator Panel. The CNC will request
	confirmation before starting to execute the program.

CNC 8070

(SOFT V03.0X)

58