Operating manual
7.3.1Block execution
7.
MDI MODE | MDI screen |
| Full |
In this window, it is possible to edit and execute new blocks or the ones saved in the block history.
Block editing
The blocks may be edited directly on the edit line or may be recalled from the block history.
Keys for selecting a block from history
To access the history and select a block.
To accept the selection and show the block on the edit line.
To cancel the selection and quit the MDI mode.
The recalled blocks may be modified before executing them as if they were new ones.
The blocks edited or modified appearing on the edit line may be executed or saved in the block history.
Saving a block
Press [ENTER] to save a block in the history without executing it.
If it is a new block, it will be added to the history whereas if it is modified block, it will replace the previous one in the history.
Block execution
The block on the edit line is executed by pressing [START] at the operator panel. Once the block has been executed is saved in the block history.
The [STOP] key interrupts the execution of the block. Press [START] again to resume execution from where it was interrupted.
The [RESET] key cancels the execution of the block and resets the CNC to its initial conditions.
CNC 8070
(SOFT V03.0X)
158
