Siemens SITRANS FUS1010 NEMA-4X/ IP 65 Graphic Display Screens, NFM-3J System Info Menu Structure

Section 4		1010NFM-3J
		System Info Menu Structure
	Version	This is the meter’s operating system version number. The Technical Services
		Group may request this number during consultations.
	Reset Date/Time	Shows the date and time of this meter’s last <F4> reset.
	Op System P/N	Meter’s operating system part number.
	Checksum	Operating System verifying code. The Technical Services Group may request this
		number during consultations.
	Code	Software Compile Date/Time. Operating System identifier. The Technical Services
		Group may request this number during consultations.
	System Time	Use to set system time and date. Format: xx.xx.xx xx.xx.xx

4.11THE 1010 GRAPHIC DISPLAY SCREENS

The 1010 family Graphic Display Sub-System is a versatile resource which provides visual access to all system variables and conditions. Depending upon your selection, details of the display my vary, but all elements are always clearly labeled with units and variable names. You’re always free to move through the displays by using the arrow keys. The meter will hold the last display selected indefinitely or until the menu is selected by pressing the <Menu> key. When you again leave the menu, the last selected display will be shown upon your return.

After completing the Site Setup, Check your local display screen to ensure that everything is operating properly. The meter begins to measure flow as soon as you complete the transducer installation.

When you press MENU to leave the menu, you will see the hybrid digital display screen (see page 4- 17). Note that it includes a digital flow, total numeric display and a Stripchart.

The StripChart Contains a number of special elements that deserve mention:

zThe spanning of the stripchart’s vertical axis obeys the same user settings that define the span limits for the analog outputs. If the variable “pegs,” the numerical expression of that variable will also peg.

zAlarm limits, or thresholds, are indicated by triangular cursors shown near the stripchart bar. These are also defined in the Data Span/Set/Cal area of the menu.

zEach time the stripchart is altered in a manner that can cause misinterpretation of already dis- played data (re-spanned, new interval, etc.), a vertical bar is drawn on the stripchart. Only the data to the left of the vertical bar is correctly displayed.

zDue to limitations in display area, certain rate or total units may be displayed with fewer characters than are needed for unambiguous interpretation. Consult the 1010’s Flow and Total Units menu cells for clarification in these cases.

4-16