Siemens SITRANS FUS1010 NEMA-4X/ IP 65 manual Data Display, Time Base

Section 2 1010NFM-3J

Valc and Vaer use the span settings from the [Data Span/Set/Cal] menu. The following data Items are available for the Stripchart Display:

•	Vfo	(spanned flow) *default
•	Vfab	(spanned unsigned flow magnitude)
•	Visc	(viscosity)
•	Temp	(temperature)
•	Vs	(sonic velocity)
•	Valc	(signal amplitude)
•	Vaer	(aeration/cavitation)
•	Vsg	(spanned unsigned flow magnitude)

To select a data item for the stripchart:

To access the [Select Data] option list press

Move the cursor to the desired item by pressing

To store your selection press ENT

2.8.2 DATA DISPLAY

The [Data Display] option list allows you to select a format for the stripchart plot. It offers the choice of displaying data either in the current data rate units or as a percent of span defined in the Data Span/ Set/Cal menu. [Data Rate Units] is the default selection.

To select a format for the data display:

To access the [Data Display] option list press

To move the cursor to the required scale unit press

To store your selection press ENT

2.8.3 TIME BASE

The [Time Base] option list defines the stripchart x-axis display interval. The stripchart plots an average of readings obtained during the elapsed time between reports. Stripchart resolution is 1 data point per pixel, of which there are approximately 100 on the short strip-chart plot and approximately 200 on the full screen stripchart plot. Five pixel reports occur between major stripchart divisions.

NOTE: The stripchart display identifies the “real time” when the computer records the most recent graduation. You can time-stamp any graduation by counting back in graduation intervals. The default interval setting is 1 second.

To select a Time Base:

To access the [Time Interval] option list press

Move the cursor to the desired interval by pressing

To store your selection press ENT

2-51