Siemens SITRANS FUS1010 NEMA-4X/ IP 65 NFM-3J System 1010 Analog Outputs, Vfo, Vfab, Valc, Vaer

Section 2				1010NFM-3J
	System 1010 Analog Outputs
	Io (Isolated current)		4 to 20 mA varies in proportion to an assigned data function.
	Vo (DC voltage)		0 to 10 Vdc varies in proportion to an assigned data function.
	Pgen (TTL logic)		0 to 5000 Hz varies in proportion to an assigned data function.
		Analog Out Setup Data Categories
		Vfo		Spanned volumetric/mass flow rate
		Vfab		Spanned unsigned flow magnitude
		Vs		Spanned liquid sonic velocity
		Valc		Receive signal amplitude
		Vaer		Relative degree of liquid aeration/cavitation
		Vsg		Spaned specific gravity
		Viscosity		System liquid viscosity
		T1		Current liquid temperature
		Iin1, Iin2		Represents a re-transmit of the analog input signals (e.g.,
				Pressure and Temp inputs can be transmitted on the 4/20
				mA output.)
		Iin3, Iin4		Same as Iin1 and Iin2 above but only available for opera-
				tion in Multi-Beam and Arithmetic modes.

NOTE: For Multi-Channel meters, refer to drawing 1010MN-7 for details. For Expanded I/O modules, refer to drawing 1010N-7-7 and Addendum 1010FMA-14 for details.

Table To Determine Proper I/O Installation Drawings

Model Number and I/O Module	Installation Drawing and Page Number*
1010N	1010N-2-7 (Sheet 2 of 2)
1010N with 1010N-7 Expanded I/O Module	1010N-7-7 (Sheet 2 of 3)
1010DN	1010N-2-7 (Sheet 2 of 2)
1010DN with 1010N-7 Expanded I/O Module	1010N-7-7 (Sheet 2 of 3)

*Note: For Ultra Precsion transducers see 1010N-7-7 (sheet 3 of 3).

Assigning Io Output Functions

The Io analog output is a self-powered, isolated 4-20mA DC signal that varies linearly in relation to a selected data function.

CAUTION: Do not connect to a powered loop.

To assign a function for the current output:

From [Analog Out Setup], press twice to access the [Io] option list.

To move the cursor to the desired data function press

To store selection press ENT

2-59