Siemens SITRANS FUS1010 NEMA-4X/ IP 65 manual Install Completed?

Section 2 1010NFM-3J

After transducers are properly mounted, the flow computer completes its Initial Makeup command and the [Install Completed?] menu cell appears.

To access the [Install Completed?] option list, press the <Right Arrow>.

Press <Down Arrow> and scroll to the [Install Completed?] menu cell and then press <ENT> (unless otherwise directed to do so by Controlotron’s Technical Service Department).

Siemens	2 Channel	[1] SITE1
Key [Install] after mounting transducers
Transducer Model		1011 Universal
Transducer Size		B3
Xdcr Mount Mode		Direct
Spacing Offset		Minimum
Number Index		4
Spacing Method		Track 1012TP
Ltn Value (in)		0.217
Install Completed?		No
Empty Pipe Set		Channel Not Setup
Zero Flow Adjust		Channel Not Setup

Pick/Install Xdcr

Press <ENT>. The [Install Completed?] menu cell will indicate [Yes] after the 1010 is successfully installed.

Siemens	2 Channel	[1] SITE1
Key [Install] after mounting transducers
Transducer Model		1011 Universal
Transducer Size		B3
Xdcr Mount Mode		Direct
Spacing Offset		Minimum
Number Index		4
Spacing Method		Track 1012TP
Ltn Value (in)		0.217
Install Completed?		Yes
Empty Pipe Set		Channel Not Setup
Zero Flow Adjust		Channel Not Setup
Pick/Install Xdcr

To complete the Install process proceed to page 2-27 and disregard the following paragraphs explaining the Force Transmit and Force Frequency diagnostic software routines.

NOTE: If the transducers have been installed successfully but the Estimated Vs (sonic veloc- ity) has been changed, the Pick/Install Xdcr menu cell [Install Completed?] option list will also display the [Transfer Install] function selection. The Transfer Install function allows the transducers to be optimally positioned for a different fluid, without the need for a new Initial Makeup procedure (see the Water Calibration addendum in this manual for details).

2-26