Section 1 | ||
|
|
|
1.5THE 1010N KEYPAD
The 1010N integral keypad provides 32 numeric and function keys (see table below). Use these keys to enter, review or edit the site data. Certain keys control the graphics display, Datalogger and Totalizer. “Blind Models,” having no keypad or display, must be setup by using their serial data port (see Appen- dix B).
| KEYPAD FUNCTION CHART |
KEY | USAGE |
MENU | Press to activate the Installation Menu. |
ENT | Press <ENT> to store numeric data, select from option lists, etc. |
LEFT, RIGHT ARROWS | Menu navigation keys move cursor in respective directions. |
UP, DOWN ARROWS | Same as <Left> and <Right>. Also scrolls option list and graphic |
| display screen. |
CLR | Clear Key for erasing data, or selecting list options. |
NUMBERS | Use to type numeric data. |
DECIMAL POINT | Use for decimal points in numeric data. |
MATH OPERATORS | Allows |
“F” KEYS | Totalizer control and special function keys. |
“F4” KEY | CAUTION: SYSTEM RESET KEY (during power up) |
CTL & ALT | Used as shift keys for alternate key functions. |
DATALOG | Triggers immediate Datalogger report. |
PLUS/MINUS | Changes the sign of numeric data. |
NOTE: The keypad does not have alphabetic keys. Scrolling lists provide alphanumeric char- acters as needed.
1.6INTRODUCTION TO THE 1010N MENU SCREENS
The figure below shows a typical 1010N menu screen (in this case, the Pipe Data Menu).
Menu Prompt Line (Reverse Video)
Highlighted
Menu Cell
Menu Cell Data
Current Selected |
|
| Current Selected |
|
| Measurement | |
Meter Type |
|
| Channel |
Siemens | 2 Channel [1] | SITE 1 | |
Select Pipe Class from Pipe Table |
| ||
Select Pipe Class | Manual Entry | ||
Select Pipe Size |
| No Pipes |
|
Pipe OD <in> |
| 0.500 |
|
Pipe Material |
| Steel |
|
Wall Thickness |
| 0.100 |
|
Liner Material |
| None |
|
Liner Thickness |
| 0.000 |
|
Pipe Dataiquid Class |
|
| |
Site Name Identified
Highlighted Data
Menu Cell Data
Current Selected Menu
