Appendix | |
|
|
Navigating Through the Installation Menu
After accessing the Installation Menu, you can begin to setup your flowmeter according to the instruc- tions in this manual. The chart below shows the PC keyboard equivalents to the 1010 keypad keys while you are in the menu.
1010 Keyboard | PC Keyboard | Description |
<Up Arrow> | <Up Arrow> | Move up 1 menu cell (or Flow Display screen) |
<Down Arrow> | <Down Arrow> | Move down 1 menu cell (or Flow Display screen) |
<Right Arrow> | <Right Arrow> | Move right 1 menu cell (or Flow Display screen) |
<Left Arrow> | <Left Arrow> | Move left 1 menu cell (or Flow Display screen) |
<Menu> | ^L (Cntrl L) | Toggle between Menu and Flow Display |
<Datalog> | ^D (Cntrl D) | Generate Datalogger report |
<CLR> | <Backspace> or <DEL> | Deselect list selection |
<ALT+Up Arrow> | ^U (Cntrl U) | Logger Display Page Advance |
(bar, shift + backslash) | Change numeric sign. Can also type | |
<ENT> | <Carriage Return> | Enter Key |
Digits | Digits | Numerals zero through 9 |
/ | / | Divide by |
X | * (upper case 8) | Multiply by |
+ | + | Plus |
- | - | Minus |
= | = | Equals |
. | . | Decimal Point |
Terminal Mode Menu Commands
In addition to Menu, the following commands (followed by the <ENT> key) can be used to control the flowmeter while in Terminal Mode.
Note that “n” refers to the flowmeter Channel number. For a dual channel Arithmetic site (Ch1 + Ch2 or Ch1 – Ch2) the virtual Channel is number 3.
Logger – Invokes the download of all data stored in the datalogger. Note that the datalogger data is not erased from the flowmeter memory when it is downloaded. It is recommended to capture this information into a file with a “csv” extension, which can be easily imported into MS EXCEL.
SITE – Invokes a full site download for a single channel or
SITE “n” – Invokes a site download for channel “n”, where “n” = the Channel # (1, 2, 3, 4, etc.).
DP “n” – Commands the flowmeter to download the digitized receive signal data for Channel or Path “n”.
CLRTOT – Clears the Totalizer for a single channel or
?– Provides a list of available Terminal Mode meter commands.
