Siemens SITRANS FUS1010 NEMA-4X/ IP 65 manual Reflect Mode Mounting Frames and Spacer BAR

Section 3 1010NFM-3J

3.1.5 REFLECT MODE - MOUNTING FRAMES AND SPACER BAR

The combination of a spacer bar with mounting frames is the easiest way to mount in Reflect Mode. The result is a rigid structure that eliminates spacing measurements, and maintains the transducer-to- transducer geometry. In addition, reflect mounting allows you to move the entire assembly while main- taining the original transducer spacing.

Mounting Strap positioned around

Mounting Strap

Mounting Frame

positioned around Mounting Frame

Optional on larger pipes, you can link straps together to surround pipe Optional on larger pipes,

you can link straps together to surround pipe.

Spacepacer BarBarPlatformPlatform&&

Clampinglamping ScrewScrew

Spacepacer BarBar

((Frontront view)View)

Mounting Straptrap

Adjustingting Screwscrew

INSTALLATION - REFLECT MOUNT WITH FRAMES AND SPACER BAR

NOTE: Minimum Ltn 0.75 in. (18 mm)

SpacerSpacerBar

TransducerTransducerClampingl

ScrewScr

Spring Clip

Spring Clip (Not present on (Not present on some some models) models)

SpacerSpacerBarBar

PlatformPlatformandand clampingclampingscrewscrew

10121012SeriSeriess

MountingMountingFrameFrame

Mountingunting StrapStrap

Note optionaloperational2 d 2ndMountingMountingStrapStrap

shown..

Largerr pipesi es maymay

needananadditionaladditional strapr forfor aamoremore securecure mountmount.

1.Perform all required menu steps until the flow computer issues the number index and prompts you to pressENTto finish the transducer install routine. Stop at this point.

Note the number index value displayed in the Pick/Install menu. You will use this number to properly space the transducers. Check to ensure that you have a matched set of transducers. They both should have the same S/N number but marked with either an “A” or “B” (e.g., 100A and 100B).

3-4