Hyundai HI4 Monitoring, 143938 ** DI Sig assignment ** A0 S4, External start External stop

6. System setting

------------------------------------------------------------------------------------------------

14:39:38 ** DO Sig assignment **						A:0 S:4
GUN (squeeze) Sig = G1 [			1	]		G2 [	2]
MX(Unfolding) Sig = X1 [			3]			X2 [	0]
Alarm to welding system					=	[	0]
Weld stick warning					=	[	0]
Program end					=	[	7]
Synthetic error					=	[	8]
Emegency stop					=	[	0]
Manual mode					=	[	0]
Collision sense					=	[	0]
Step set warning					=	[	0]
Interlock-abnormal warning					=	[ 13]
Select and Enter number. Press					[SET]
>[1 - 256]
All Form	One Form	Previous	Next			Complete

⑵One initialize: Presently selected output assignment signal value return to the initialize status.

⑶Assigned DO signal displays the small character in the "Service"[PF1] → 1.

MONITORING.
ex) In	case of not assigning :		O31
In	case of assigning	:	o31

⑷If press “ Complete” [PF5], Save changed information. if press [Cancel]Key, Cancel them.

6.2.1.7Input signal assignment

Outline

It uses the signal after output signal assign in special DI signal.

Screen display

14:39:38 ** DI Sig assignment ** A:0 S:4

External start						=	[	23		]
External stop						=	[ 24]
Prog selection bit=				BO1[ 25]			BO2[ 26]
				BO3[ 27]			BO4[ 28]
				B05[ 29]			BO6[ 30]
				B07[ 31]			BO8[ 32]
Program Strobe						=	[		0]
Binary/Discrete(OFF->Binary) =							[		0]
External reset						=	[		0]
Low speed command						=	[		0]
WI			=	W1 [ 22]			W2 [		0]
Select and Enter number. Press							[SET]
>[1-256]
All Form	One Form	Previous			Next		Complete

----------------------------------------------------------------------------------------

6 - 21