Hyundai HI4 operation manual Former times is ineffective

6. System setting

------------------------------------------------------------------------------------------------

Example2) In case of setting the 1 axis positioner and the 2 axis positioner

(It is corresponded in case that all the additional 3 axes are set to the JIG.)

Additional Axis		Positioner Group
----------------		----------------
T1	Axis -------------	> [1]
T2	Axis -------------	>	[2]
T3	Axis -------------	>	[2]

It is the case that the T1 axis singly makes the first group of positioner in the group 1 and makes the positioner 2 group by collating with T2 and T3.

Example3) In case that the 1 axis positioner exists two unit.

Additional Axis		Positioner Group
----------------		----------------
T1	Axis -------------	> [1]
T2	Axis -------------	>	[1]
T3	Axis -------------	>	[0]

It is the case that the T1 axis makes the positioner 1 group and the T2 axis makes the positioner 2 group.

Example4) In case of setting to the Jig axis that doesn't synchronize.

Additional Axis		Positioner Group
----------------		----------------
T1	Axis -------------	> [0]
T2	Axis -------------	>	[0]
T3	Axis -------------	>	[0]

It is the case that uses the basic value.

⑵The method that designates the positioner group.

①The designation of group should be carried out according to the order from low axis.

② The group that doesn't synchronize is designated to [0] and should be set next to the axis that synchronizes.

③ You should not designate the 3 axis to the same group because the same group of positioner supports only till the 2 axis.

④ You should press the "Complete"[PF5] key to finish the group setting right. ⑤ In case of defining the group setting again, you should execute the calibration of positioner again because the constant value of positioner designated in the

former times is ineffective.

----------------------------------------------------------------------------------------

6 - 105