Efficient Networks S120 Password, Parameter overview for password see Sinamics S List Manual

Safety Integrated basic functions 9.1 General information

Password

The safety password protects the safety parameters against unauthorized write access.

In commissioning mode for Safety Integrated (p0010 = 95), you cannot change safety parameters until you have entered the valid safety password in p9761 for the drives or p10061 for the TM54F.

●When Safety Integrated is commissioned for the first time, the following applies:

–Safety password = 0

–Default setting for p9761 = 0

In other words:

The safety password does not need to be set during initial commissioning.

●In the case of a series commissioning of Safety or in the case of spare part installation, the following applies:

–The safety password is retained on the CF card and in the STARTER project.

–No safety password is required in the case of spare part installation.

●Change password for the drives

–p0010 = 95 Commissioning mode

–p9761 = Enter "old safety password".

–p9762 = Enter "new password".

–p9763 = Confirm "new password".

–The new and confirmed safety password is valid immediately.

●Change password for the TM54F

–p0010 = 95 Commissioning mode

–p10061 = Enter "Old TM54F Safety Password" (factory setting "0")

–p10062 = Enter "new password"

–p10063 = Acknowledge "new password"

–The new and acknowledged safety password is valid immediately.

If you need to change safety parameters but you do not know the safety password, proceed as follows:

1.Set the entire drive unit (Control Unit with all connected drives/components) to the factory setting.

2.Recommission the drive unit and drives.

3.Recommission Safety Integrated.

Parameter overview for password (see SINAMICS S List Manual)

●p9761 SI password input

●p9762 SI password new

●p9763 SI password acknowledgement

●p10061 SI password input TM54F

Drive Functions	305
Function Manual, (FH1), 07/2007 Edition, 6SL3097-2AB00-0BP4