Efficient Networks S120 manual Information on the displays, Information on the keys, Display, Key

Basic information about the drive system 12.6 Parameterizing using the BOP20 (Basic Operator Panel 20)

Information on the displays

Table 12-7 LED

Display

top left

2positions

RUN

top right

2 positions

S

P

C

Below, 6 digit

Meaning

The active drive object of the BOP is displayed here.

The displays and key operations always refer to this drive object.

Lit if at least one drive in the drive line-up is in the RUN state (in operation). RUN is also displayed via bit r0899.2 of the drive.

The following is displayed in this field:

•More than 6 digits: Characters that are still present but are invisible (e.g. "r2" ––> 2 characters to the right are invisible, "L1" ––> 1 character to the left is invisible)

•Faults: Selects/displays other drives with faults

•Designation of BICO inputs (bi, ci)

•Designation of BICO outputs (bo, co)

•Source object of a BICO interconnection to a drive object different than the active one.

Is (bright) if at least one parameter was changed and the value was not transferred into the non- volatile memory.

Is lit (bright) if, for a parameter, the value only becomes effective after pressing the P key.

Is light (bright) if at least one parameter was changed and the calculation for consistent data management has still not been initiated.

Displays, e.g. parameters, indices, faults and alarms.

Information on the keys

Table 12-8	Keys
Key	Name
	ON
	OFF

Functions

Parameters

Raise

Lower

Meaning

Power-up the drives for which the command "ON/OFF1" should come from the BOP. Binector output r0019.0 is set using this key.

Powering-down the drives for which the commands "ON/OFF1", "OFF2" or "OFF3" should come from the BOP.

The binector outputs r0019.0, .1 and .2 are simultaneously reset when this key is pressed. After the key has been released, binector outputs r0019.1 and .2 are again set to a "1" signal.

Note:

The effectiveness of these keys can be defined by appropriately parameterizing the BICO (e.g. using these keys it is possible to simultaneously control all of the existing drives).

The significance of these keys depends on the actual display.

Note:

The effectiveness of this key to acknowledge faults can be defined using the appropriate BiCo parameterization.

The significance of these keys depends on the actual display.

If this key is pressed for 3 s, the "Copy RAM to ROM" function is executed. The "S" displayed on the BOP disappears.

The keys depend on the current display and are used to either raise or lower values.

Drive Functions	491
Function Manual, (FH1), 07/2007 Edition, 6SL3097-2AB00-0BP4