Efficient Networks S120 manual 540

Appendix

A.2 Availability of SW functions

No.	SW function	available	Servo	Vector	HW component
		since FW
9	Edge modulation (higher output voltages) in the vector	2.5	-	x	only for DAC Motor
	control type, also with booksize devices				Modules
					(6SL3xxx-xxxxx-
					0AA3)
10	DC braking	2.5 SP1	x	x
11	Armature short-circuit: Internal	2.5 SP1	x	x
12	Armature short-circuit: Intermittent voltage protection	2.5	x	-	only for DAC Motor
					Modules
					(6SL3xxx-xxxxx-
					0AA3)
13	Automatic firmware update for DRIVE-CLiQ components	2.5	x	x
14	Save STARTER project direct to CF card	2.5	x	x
15	The terminal area for booksize infeeds (BLM, SLM, ALM)	2.5 SP1	x	x	only for booksize
	can be parameterized to 230 V 3 AC				DAC infeeds
					(6SL3xxx-xxxxx-
					0AA3)
16	Automatic speed controller setting	2.5	x	since
				FW2.1
17	Technological pump functions	2.5	-	x
18	Simultaneous cyclical operation of PROFIBUS and	2.5 SP1	x	x
	PROFINET on CU320
19	Automatic restart also with servo	2.5 SP1	x	since
				FW2.2
20	Operates at 500 μs PROFINET I/O	2.5 SP1	x	-
21	Absolute position information (X_IST2) with resolver	2.5	x	x
22	DC link voltage monitoring depending on the line voltage	2.5	x	x
23	Automatic line frequency detection	2.5	x	x
24	Acceleration signal at the ramp function generator output	2.5	x	x
25	Reset the drive device via parameter (p0972)	2.5	x	x
26	Alteration of the basic sampling time during the automatic	2.5	-	x
	readjustment of the sampling times depending on the
	number of drives on CU320 with vector (from 400 µs to
	500 µs)
27	Dynamic energy management, extension of the Vdc_min,	2.5	x	x
	Vdc_max control
28	Endless trace	2.5	x	x
29	Extended PROFIBUS monitoring with timer and binector	2.5	x	x
30	Indexed actual value acquisition	2.5 SP1	x	x
	Simultaneous evaluation of multiple encoders

540	Drive Functions
	Function Manual, (FH1), 07/2007 Edition, 6SL3097-2AB00-0BP4