NEC N 1093100, P Operation, To set up a Conference, Unsupervised Conference page 341 for more

Conference
	Operation
				Setting up a Conference	In these instructions:
					[Super Display Soft Key]
					[Keyset Soft Key]
To set up a Conference:
1.		Establish an Intercom or outside call.
2.		Press CONF.
		• Your hear Intercom dial tone.
		• Your caller hears Music on Hold (if installed) while they wait for you to set up the Conference.
3.		Do one of the following:
		a.	Dial extension you want to add.
		b.	Place or answer an outside call.
		c.	Retrieve a call from Park Orbit.
4.		Press CONF to set up the Conference.
		• If you cannot add additional parties to your Conference, you have exceeded the system’s Conference limit.
5.		Repeat steps 2-4 to add additional parties to your Conference. You can also do one of the following.
		a.	To optionally place a Conference on Hold:
				Press HOLD.
		b.	To reinstate the Conference on Hold.
				Press CONF.
				Exiting a Conference	In these instructions:
					[Super Display Soft Key]
					[Keyset Soft Key]
To exit a Conference without affecting the other parties:
1.		Hang up.
		• The remaining parties can continue their conversation uninterrupted.
		• If you were in Conference with two outside lines, this may set up a tandem call. Refer to Tandem Calls /
		Unsupervised Conference (page 341) for more.
			Using Conference at a Single Line Telephone		In these instructions:
					[Super Display Soft Key]
					[Keyset Soft Key]
To use Conference at a single line telephone:
1.		Establish an Intercom or outside call.
2.		Hookflash and dial the extension or outside line you want to add.
3.		Hookflash and dial #10 to set up the Conference.
		• If you cannot add additional parties to your Conference, you have exceeded the system’s Conference limit.
4.		Repeat steps 2 and 3 to add additional parties to your Conference.

90 ◆ Features DSX Software Manual