NEC Initial Startup Programming, Default Feature Setup, Introduction, DSX Software Manual

Default Feature Setup

Initial Startup Programming

1.Enter the programming mode.

1.From any display telephone:

-Press INTERCOM + Dial #*#*

-Enter the system password + HOLD

2.The system passwords are:

-632379 (NECDSX) for Installer (level 3)

-9999 for System Administrator 2 (level 2)

-0000 for System Administrator 1 (level 1)

3.See System Programming Password Protection (page 336) for more.

2.Assign the correct circuit type to each of your installed lines.

1.In 3101-01: Line Type (page 809), assign the correct circuit type for each line. Analog line types are:

-51 for loop start DTMF

-52 for loop start DP

3.By default, each extension has full incoming and outgoing access to each line. To change this assignment:

1.If yes, in 2131-[01-64]: Line Access (page 763), change each extension’s line access as required:

-0 for no access

-1 for incoming access only

-2 for outgoing access only

-3 for full access

2.Using 902x-Copy(page 921) may save you time.

4.By default, all extensions 300-315 ring immediately day and night for on lines 1-12. To change this assignment:

1.In 2132-[01-64]: Line Ringing (page 764) set the ringing option for each extension:

-0 for lamp only (no ringing) day and night

-1 for day and night ringing

-2 for night ringing only

-3 for delay ringing day and night

2.Using 902x-Copy(page 921) may save you time.

5.To change the default system passwords:

1.Turn to System Programming Password Protection (page 336) to learn more about system passwords.

6.To return the system to the factory installed (default) programming:

1.Turn to 901x-Initialize (Initialize Utilities) (page 917) to learn more about system initialization.

Introduction

DSX Software Manual Introduction ◆ 3