NEC Automatic Slot Configuration, Description, Programming, Other Related Features, Operation

Models: P N 1093100

1 984
Download 984 pages 47.76 Kb
Page 63
Image 63
Automatic Slot Configuration

Automatic Slot Configuration

Automatic Slot Configuration

Description

The system automatically installs PCBs when you power up the system.

Automatic Slot Configuration automatically sets up station and line PCBs when you initially power up the system. This simplifies installation because you don’t have to use system programming to activate station and line PCBs after you plug them in.

Here’s how Automatic Slot Configuration works:

1.With power off, install your station and line PCBs.

2.With the system powered down, install the station and line PCBs from left to right in the order you want your extension and line numbers set up.

Be sure to install a 16ESIU PCB in the first slot (CN1).

You don’t have to group your station and line PCBs together, although it may be more convenient to do so.

3.Power up the system.

4.On power up, the system scans the PCBs from left to right and sets up the extension and line numbering as follows.

Extension numbers will begin with 300 in the first slot and increment from left to right.

Line numbers will begin with 101 (starting from the first installed line PCB) and will also increment from left to right.

System reset does not cause reconfiguration. Automatic Slot Configuration is temporarily disabled during a system reset.

Programming

1.Optionally reconfigure station PCBs after the initial installation.

1.Use 120x-Stations(page 611) to reconfigure your station PCBs.

2.Optionally reconfigure line PCBs after the initial installation.

1.Use 121x-Lines(page 614) to reconfigure your line PCBs.

Other Related Features

None

Operation

N/A

Features

DSX Software Manual

Features 33

Page 63
Image 63
NEC Automatic Slot Configuration, Description, Programming, Other Related Features, Operation, DSX Software Manual