Honeywell UDC2500 manual Viewing the operating parameters, Lower Display Key Parameter Prompts

Monitoring and Operating the Controller

4.5.2 Viewing the operating parameters

Press the LOWER DISPLAY key to scroll through the operating parameters listed in Table 4-3.The lower display will show only those parameters and their values that apply to your specific model.

Table 4-3 Lower Display Key Parameter Prompts

Lower Display

Description

	OT XX.X	OUTPUT—Output value is percent; for Three Position Step control, this is an
		estimated motor position and shown with no decimal place.
	SP XXXX	LOCAL SETPOINT #1—Also current setpoint when using SP Ramp.
	2LXXXX	LOCAL SETPOINT #2
	RSXXXX	REMOTE SETPOINT
	2NXXXX	INPUT 2
	DEXXXX	DEVIATION—Maximum negative display is –999.9.
	PIDS X	TUNING PARAMETER SELECTED SET—where X is either 1 or 2.
	HH.MM	TIME REMAINING—Time that remains on timer in Hours.Minutes
		ELAPSED TIME—Time that has elapsed on timer in Hours.Minutes.
	RPXXXM	SETPOINT RAMP TIME—Time remaining in the setpoint ramp in minutes.
	AX XXX	AUXILIARY OUTPUT
	SnXXXX	SP RATE SETPOINT—Current setpoint for setpoint rate applications
	BIXXXX	BIAS—Displays the manual reset value for algorithm PD+MR.
	To BGn	TO BEGIN—Resets Setpoint Program back to beginning of the program.
	NoTUNE	Unit is currently not in Accutune process.
	DoSLOW	Accutune Slow tuning process is operating.
	DoFAST	Accutune Fast tuning process is operating.
POSXX.XX		Three position

94 UDC2500 Universal Digital Controller Product Manual 4/07