Honeywell UDC2500 manual SP Ramp/Rate/Program, Set-up Group Setpoint Ramp/Rate

Modbus Read, Write and Override Parameters plus Exception Codes

10.7.2SP Ramp/Rate/Program

Table 10-10lists all the register addresses and ranges or selections for the function parameters in Set-up Group Setpoint Ramp/Rate.

	Table 10-10 Set-up Group – Setpoint Ramp/Rate
Parameter	Register		Data	Access		Data Range or
Description	Address		Type			Enumerated Selection
	Hex	Decimal
SP Ramp	0096	150	INT	R/W	0	= Disabled
					1	= Enabled
Single SP Ramp	19	25	FP	R/W	0 to 255 (minutes)
Time
Final Ramp SP	001A	026	FP	R/W	PV Range in Engineering
Value						Units
SP Rate	F0	240	INT	R/W	0	= Disabled
					1	= Enabled
Rate Up (EU/HR)	006C	108	FP	R/W	0 to 9999
Rate Down	006D	109	FP	R/W	0 to 9999
(EU/HR)
Setpoint	00B2	178	INT	R/W	0	= Disabled
Program					1	= Enabled
Start Segment #	58	88	FP	R/W	1 to 12
End Segment	00B0	176	INT	R/W	0	= Soak 2
#(Soak)					1	= Soak 4
					2	= Soak 6
					3	= Soak 8
					4	= Soak 10
					5	= Soak 12
Engineering Units	00B6	182	INT	R/W	0	= HRS:MIN
or Ramp					1 = Degrees/Minute
Segments					2 = EU/Hour
Program Recycles	59	89	FP	R/W	0 to 100
Guaranteed Soak	0057	087	FP	R/W	0 to 99.9 (0 = no soak)
Deviation
Program End	00B5	181	INT	R/W	0	= Disable SP Program
State					1	= Hold at Program End

198 UDC2500 Universal Digital Controller Product Manual 4/07