1590 System Management Commands
Default Configuration
The default is media-type auto-select sfp.
Command Mode
Interface Config
User Guidelines
When both media types are connected, the preference as determined by the
auto-select keyword parameter selects the active media. When the auto-select
keyword is not specified, the selected media type is powered on and the
alternate media type is powered off. Note that when the auto-select keyword
is used with any media type, the SFP port will remain powered and the laser, if
any, will remain on in order to allow connections over the SFP port.
Example
! Select the RJ45 port and power off the SFP port
console(config-if-Te1/0/24)#media-type rj45
! Prefer the RJ45 port and leave the SFP port powered on
console(config-if-Te1/0/24)#media-type auto-select rj45
member
Use the member command in Stack Global Configuration mode to pre-
configure a switch stack member. Execute this command on the Management
Switch. To remove a stack-member configuration from the stack, use the no
form of the command.
NOTE: The "no" form of the command may not be used if the member is present in
the stack.
auto-select Return the selection to the default (auto-select sfp)
rj45 Force connection on the RJ45 port. Power off SFP media port.
sfp Force connection on the SFP port. Power off RJ45 media port.
Parameter Description
2CSPC4.XCT-SWUM2XX1.book Page 1590 Monday, October 3, 2011 11:05 AM